One way issues

Here you can discuss everything you do to keep your car running 100%.
boxhead1990
Rally Style Drifting
Rally Style Drifting
Posts: 30
Joined: Fri Oct 04, 2013 10:08 am
Drift Chassis: Hsp flying fish
Location: Brisbane Australia

One way issues

Postby boxhead1990 » Mon Feb 24, 2014 7:42 am

Okay so I tryed cleaning with the rubbing alcahole method several times now but I'm still having an issue with one of the bearings slipping it's into mutant (on and off) like at low throttle it just slips till you give it everything (tends to snap a cvd as soon as it grips again

Iv tryed several differant out drives and there all new and fine they do the same thing

Anyone have any idea I can try out next?

Also I even have it a dry run with no lube after cleaning appeared to work right for a few mins then went back to doing this again

User avatar
tokeyo83
Banned and Dumb
Posts: 542
Joined: Wed Jan 06, 2010 2:23 am
Drift Chassis: HB Cyclone TC-H / Yokomo MR4-TC DP (WIP)
Location: Artesia, Ca

Re: One way issues

Postby tokeyo83 » Mon Feb 24, 2014 4:09 pm

Does it snap the cvds on both sides or just one? Maybe check the bearings on the knuckles, your cvds shouldn't snap so easily when the oneway grips/engages.
"there are no stupid questions, just stupid people"

boxhead1990
Rally Style Drifting
Rally Style Drifting
Posts: 30
Joined: Fri Oct 04, 2013 10:08 am
Drift Chassis: Hsp flying fish
Location: Brisbane Australia

Re: One way issues

Postby boxhead1990 » Tue Feb 25, 2014 7:18 am

Just the one side and the outdrive slips until you give it full throttle pretty much I think the one way bearing might be faulty as it's had dramas since the 2nd time using it


Return to “Maintenance Tips”

Who is online

Users browsing this forum: No registered users and 2 guests